Electrolux 40036VI-WN user manual Care and cleaning, Installation

4Safety information

•Cookware made of cast iron, cast aluminium or with damaged bottoms can scratch the hob surface if you move them on the surface.

•Discoloration of the enamel has no effect on the performance of the appliance.

•To prevent damage or discoloration to the enamel:

–do not put any objects directly on the appliance floor and do not cover it with alumi- nium foil;

–do not put hot water directly into the appliance;

–do not keep moist dishes and food in the appliance after you finish the cooking.

•Do not apply pressure on the open door.

•Do not put flammable materials in the compartment below the oven. Keep there only heat-resistant accessories (if applicable).

•Do not cover oven steam outlets. They are at the rear side of the top surface (if applica- ble).

•If there is a crack on the surface, disconnect the power supply. There is a risk of electric shock.

•Do not put heat-conducting materials (e.g. thin metal mesh or metal-plated heat con- ductors) under the cookware. Excessive heat reflection can damage the cooking surface.

Care and cleaning

•Before maintenance, make sure that the appliance is cold. There is a risk of burns. There is a risk that the glass panels can break.

•Keep the appliance clean at all times. A build-up of fats or other foodstuff can result in a fire.

•Regular cleaning prevents the surface material from deteriorating.

•For your personal safety and the safety of your property, only clean the appliance with water and soap. Do not use flammable products or products that can cause corrosion.

•Do not clean the appliance with steam cleaners, high-pressure cleaners, sharp objects, abrasive cleaning agents, abrasive sponges and stain removers.

•If you use an oven spray, follow the instructions from the manufacturer. Do not spray anything on the heating elements and the thermostat sensor.

•Do not clean the glass door with abrasive cleaning agents or metal scraper. Heat resist- ant surface of the inner glass can break and shatter.

•When the door glass panels are damaged they become weak and can break. You must replace them. Contact the service centre.

•Be careful when you remove the door from the appliance. The door is heavy.

•Bulb lamps used in this appliance are special lamps selected for household appliances use only. They cannot be used for the full or partial illumination of a household room.

•If it becomes necessary to replace the lamp use one of the same power and specifically designed for household appliances only.

•Disconnect the appliance from the power supply before the replacement of the oven lamp. There is the risk of electrical shock. Cool down the appliance. There is a risk of burns.

Installation

•Only an approved technician can install and connect the appliance. Contact an approved service centre. This is to prevent the risks of structural damage or physical injury.

•Make sure that the appliance is not damaged because of transport. Do not connect a damaged appliance. If necessary, contact the supplier.