Emerson 225-600KVA Isometric View, Top View, Front Terminal Battery Cabinet shipping split

Liebert® NX™

14

			Cabinet A	Cabinet B
			Use M8 hardware supplied on bus
			Torque to 180 in-lb (20Nm)
			Route two supplied wires (W16)
			from Jar 1 (-) to BCB breaker in (-)	Tywrap here to
		B	Note: Install bushings first.
Install snap bushing			Tywrap here to	secure wires in place
in corner post before			secure wires in place	Use M10 hardware
routing these wires
			Remove M6 hardware	supplied on bus
Jar 28			used to secure lugs	Torque to 240 in-lb
			in place and discard	(27Nm)
			Connect lugs to bus
			directly above insulator
			and secure with M8 hardware
			supplied on bus. Typ 8 places.
			Torque to 180 in-lb (20Nm)
			Install snap
			bushing
			in corner
			post before
			routing these
Install snap bushing			wires
in corner post before		A	Route two supplied wires (W17)	Tywrap here to
routing these wires		Jar 16	from Jar 15 (+) to Jar 16 (-)	secure wires in place
			Note: Install bushing first.	Front
	Isometric View
			Remove these busbars and keep
	Install M10 washer, lockwasher		the hardware to secure busbars
	and bolt to secure units together		between Cabinet A & Cabinet B	Reuse M12 hardware
Detail A	front and rear
			Negative (-)	Torque to 480 in-lb (54Nm)
	Note: Jar 16 must be
	moved forward or removed
	to install rear hardware. Rear		Positive (+)
	cutouts are provided if rear
	access is provided.
	Install M10 washer, lockwasher
	and bolt to secure units together			Busbars shown
	front and rear
Detail B				connected between
	Note: Jar 28 must be
			Top View	Cabinet A & Cabinet B
	moved forward or removed			(busbar quantity varies)
	to install rear hardware. Rear
	cutouts are provided if rear
	access is provided.

Figure 10 Front Terminal Battery Cabinet shipping split

Installation Drawings