2--14Settings

Service — Factory Selectable Features
The controller service factory selectable features can be displayed from the
membrane controls. These factory settings shoul d not be changed by the customer
(they cannot be changed without entering the factory password) .
¡From the ATS Status display (NOR MAL OK), press Enter/Save Settings
button to move down to the Settings level of menus.
©¢£¤¥¦§ Press right arrow "button 7 times to move to Service menu.
¨Now press Enter/Save Settings button to move down to the first Service
factory selectable feature.
Youcanpress the right arrow "button to see the other Ser vice menus (as shown
below). An overview explanationof each setting is listed below.

8 Service Menus (last menu loops back to first)

ATS Information

This display shows the transfer switch amper e size, whether the switch is a
bypass switch or a non–bypass s witch, and any name or description infor m–
ation that has been assigned to it through the ser ial communications port.

Testor Manual Mode Input

This display shows the setting of the Feature 5/6Z input. This input can be
used for either Feature5 or 6Z. Yes means active; no means notused.
TestOperation — Feature 5
Manual Operation — Feature6Z
This Featureis notavailable for automatic operation.

Retransfer Mode Input

This display showsthe settings for Features 6B/6C inputs. This input can be used
for either Feature 6B or6C. Yes means active; no means not used.
TD Bypass — Feature 6B
Manual Re Xfer — Feature6C
These Features are typically set to Yes with the inhibit Feature overridden with
external factory wiring. TheseFeatures are not available for customer use.

Xfer to Normal Inhibit and Emergency (not shown)

This display shows whether the Feature 34A input is enabled (yes) or disabled
(no).
Likewise, the next display Xfer to Emerg shows whether the Feature 34B input
is enabled (yes) or disabled (no).

Factory Calibration (not shown)

This display is for factory cali bration only and should be used by factory
personnel only.

Other

These displays show variousparameters that should be accessed by factory
personnel only.
NORMAL OK
SETTINGS
VoltageDO PU
Frequency DO PU
¡
©¢£
¤¥¦§
ATSINFORMATION
ATS:
TEST OR MANUAL MODE
INPUT
TestOperation:
Manual Operation:
RETRANSFER MODE
INPUT
TD Bypass:
Manual Re Xfer:
XFER TO NORMAL
INHIBIT
Enable:
Temp C ali br:
ATSIdle Time: ms
CT Parallel TD: ms
SERVICE
Factory
SelectableFeatures
¨
press
7times