2--9 Settings

General Settings
The controller (CP) generalsetting can be displayed and changed from the keypad.
Some settings may require a password (if the controller i s set up for one).
¡From any o f the Status displays, press Enter/SaveSettings ¿key to move to
the Settings level of menus.
©Press the right arrow "key to move to Setting Time Delays menu.
¢Press the right arrow "key again to move to Settings Features menu.
£Press the right arrow "key again to move to Settings General menu.
¤Now press Enter/Save Settings ¿keytomovetothefirstGeneral display
¥Youcanpress the right arrow "key to see the other General menus (asshown
below). An overviewexplanation of each setting is listed below.

6 General Settings Menus (last menu loops back to first)

Default to Factory Settings seepage2–1

This display (upper half) allows the user to reset the majority of controller
settings to their factory default values.

Reset Engine Exerc Program s seepage2–1

This display (lower half) also allows the user to resetthe engine exerciser
routines. YES meansreset. NO means do not reset.

Menu Language (not shown) see page 2–1

Thisdisplayshowsthelanguageinwhichthemessageswillbeshown.
English is the default l anguage.

Serial Communication seepage2–1

Thisdi splay allows the user to configure the seria l communications port of the
controller.
Baud Rate — off, 9600, x9600. 19.2 k, Mbus9600, Mbus19.2k
x9600 selects 9600 and the Group 1/7 CP protocol
Address — can be set from0 to 63

Event Logging seepage2–1

This display allows the user to enable t he event logging feature of the
controller and to clear the event log.
Enable — YES means to start eventlogging; NO means turn it off.
Print Enable — YES means enables printer option; NO turns it off.
Clear Log — YES means erase the event log; NO means keep it.

PrintEventLog(not shown) see page 2–1

This display shows the status of the optional printer.
Also see Printer Interface Module instructions 381339 ---218.

User Controls Locked(on 4000 Ser ies only)

seepage2–1

Thisdi splay allows the user to lock or unlock the door–mounted user control s.
(not the Power ControlCente r). YESmeans locked. NO means unlocked.

Change Password seepage2–1

This display allows the user to change the controlle r password.
SETTINGS
VoltageDO PU
Frequency DO PU
¡
©
Defaultto Factory
Settings:
Reset Engine Exerc
Programs:
SERIAL
COMMUNICATION
Baud Rate:
Address:
EVENT LOGGING
Enable:
PrintEnable:
Clear Log:
Change
Password:
0001
SETTINGS
General
£
¤
¥
¢
User Ctrls Lckd: