Emerson ATCA-7350 2.1.7.1.2System Boot Options Parameter #96, 10System Boot Options Parameter #96

Supported Commands Chassis Device Commands

2.1.7.1.2System Boot Options Parameter #96

This boot parameter is an Emerson-specific OEM boot parameter. Its definition is given in the following table.

Table 2-10 System Boot Options Parameter #96

Boot Option
Parameter Data	Description
1	This parameter specifies the processor ID for which the boot option is to be set.
	This parameter has to be 0 always for this blade.
2	This parameter is used to select the BIOS boot bank of which the payload shall
	boot from:
	[7:1] Reserved
	[0] Default/backup boot flash selection

There is no Set Selector or Block Selector with this command.

The System Boot Options parameter #96 is non-volatile. Its parameter data remains preserved after IPMC power cycles and firmware upgrades.

2.1.7.1.3System Boot Options Parameter #98

This boot parameter is an Emerson-specific OEM parameter.

This timer specifies how long the IPMC waits for the payload to shut down gracefully. If the payload software does not configure its OpenIPMI library to be notified for graceful shutdown requests, the IPMC shuts down the payload when the timer expires.

Table 2-11 System Boot Options Parameter #98

Boot Option Parameter
Data	Description
1	This parameter specifies the Graceful Shutdown Timeout LSB (given in
	100 msec)
2	This parameter specifies the Graceful Shutdown Timeout MSB (given in
	100 msec)

20 ATCA-7350 Control via IPMI Programmer’s Reference (6806800H29E)