Emerson ATCA-7350 manual 2.3Emerson Specific Commands, 2.3.1Serial Output Commands

Emerson Specific CommandsSupported Commands

Table 2-14 Supported PICMG 3.0 Commands (continued)

	NetFn
Command	(Request/Response)	CMD	Comments
Activate firmware	0x2C/0x2D	0x35	-
Query self-test results	0x2C/0x2D	0x36	-
Query rollback status	0x2C/0x2D	0x37	-
Initiate manual rollback	0x2C/0x2D	0x38	-

The firmware upgrade commands supported by the ATCA-7350 are implemented according to the PICMG HPM.1 Revision 1.0 specification.

2.3Emerson Specific Commands

The Emerson IPMC supports several commands which are not defined in the IPMI or PICMG 3.0 specification but are introduced by Emerson: serial output commands.

zBefore sending any of these commands, the shelf management software must check whether the receiving IPMI controller supports Emerson specific IPMI commands, by using the IPMI command 'Get Device ID'. Sending Emerson specific commands to IPMI controllers which do not support these IPMI commands will lead to no or undefined results.

zImplementing any of the Emerson specific IPMI commands means that the software

is not portable to other IPMI controllers that do not use the IPMC firmware.

2.3.1Serial Output Commands

Table 2-15 Serial Output Commands

Command Name	NetFn (Request/Response)	CMD	Description
Set Serial Output	0x2E/0x2F	0x15	See Set Serial Output Command on
			page 24
Get Serial Output	0x2E/0x2F	0x16	See Get Serial Output Command on
			page 24

ATCA-7350 Control via IPMI Programmer’s Reference (6806800H29E) 23