Emerson ATCA-7350 manual 2.1.8LAN Device Commands, 2.1.7.1.4System Boot Options #99

LAN Device Commands Supported Commands

There is no Set Selector or Block Selector with this command.

The System Boot Options parameter #98 is non-volatile. Its parameter data remains preserved after IPMC power cycles and firmware upgrades.

2.1.7.1.4System Boot Options #99

This parameter is an Emerson-specific OEM parameter. It is used to enable or disable BIOS and FRU write protection

Table 2-12 System Boot Options Parameter #99

Boot Option Parameter
Data	Description
1	This parameter enables/disables BIOS and FRU write protection:
	[7:4] Bios ID (0= Boot Bank A, 1= Boot Bank B, 2= FRU information,
	others reserved)
	[3:0] write protect enable/disable (0= disable, 1= enable, others reserved)

There is no Set Selector or Block Selector with this command. The Boot Option parameter data returned with the IPMI command Get System Boot Options provides the write protect status of the two BIOS flashes and of the FRU information (one byte for each instance).

2.1.8LAN Device Commands

Table 2-13 Supported LAN Device Commands

Command	NetFn (Request/Response)	CMD
Set LAN Configuration Parameters	0x0C/0x0D	0x01
Get LAN Configuration Parameters	0x0C/0x0D	0x02
Set SOL Configuration Parameters	0x0C/0x0D	0x21
Get SOL Configuration Parameters	0x0C/0x0D	0x22

ATCA-7350 Control via IPMI Programmer’s Reference (6806800H29E) 21