Supported Commands | Serial Output Commands |
|
|
2.3.1.1Set Serial Output Command
The Set Serial Output command selects the serial port output source for a serial port connector.
2.3.1.1.1Request Data
The following table lists the request data applicable to the Set Serial Output command.
Table 2-16 Request Data of Set Serial Output Command
Byte | Data Field |
|
|
1 | LSB of Emerson IANA Enterprise number. A value of 0xCD has to be used. |
|
|
2 | Second byte of Emerson IANA Enterprise number. A value of 0x65 has to be used. |
|
|
3 | MSB of Emerson IANA Enterprise number. A value of 0x00 has to be used. |
|
|
4 | Serial connector type |
| 0: Face plate connector |
| All other values are reserved. |
|
|
5 | Serial connector instance number. A sequential number that starts from 0. |
|
|
6 | Serial output selector |
| 0: payload serial console (default 9600 baud) |
| 2: IPMC(default baud rate 115200 baud) |
| All other values are reserved. |
|
|
2.3.1.1.2Response Data
The following table lists the response data applicable to the Set Serial Output command.
Table 2-17 Response Data of Set Serial Output Command
Byte | Data Field |
|
|
1 | Completion code |
|
|
2 | LSB of Emerson IANA Enterprise number. |
|
|
3 | Second byte of Emerson IANA Enterprise number. |
|
|
4 | MSB of Emerson IANA Enterprise number. |
|
|
2.3.1.2Get Serial Output Command
The Get Serial Output Command provides a way to determine which serial output source goes to a particular serial port connector.
24 |
