Emerson ROC827 instruction manual Removing a Communications Module

ROC827 Instruction Manual

ƒIf there is a module currently in the slot, unscrew the captive screws and remove that module (refer to “Removing a Communications Module”).

ƒIf the slot is currently empty, remove the module cover.

3.Insert the new module through the module slot on the front of the ROC827 housing. Make sure the label on the front of the module is facing right side up. Gently slide the module in place until it contacts properly with the connectors on the backplane.

Note: If the module stops and will not go any further, do not force the module. Remove the module and see if the pins are bent. If so, gently straighten the pins and re-insert the module. The back of the module must connect fully with the connectors on the backplane.

4.Gently press the module into its mating connectors on the backplane until the connectors firmly seat.

5.Install the retaining captive screws to secure the module.

6.Wire the module (refer to “Wiring Communications Modules”).

Note: All modules have removable terminal blocks for convenient wiring and servicing. Twisted-pair cable is recommended for I/O signal wiring. The removable terminal blocks accept 12 AWG or smaller wire.

7.For dial-up modem communications, connect the cable to the RJ-11 connector on the communications module.

Note: If you are installing a modem module, it is recommended that you install a surge protector between the RJ-11 jack and the outside line.

8.Replace the wire channel cover.

9.Connect to ROCLINK 800 software and login. The modules are self- identifying after re-connecting to ROCLINK 800 software.

5.3Removing a Communications Module

To remove a communications module:

1.Remove the wire channel cover.

2.Unscrew the two captive screws holding the module in place.

3.Gently pull the module’s lip out and remove the module from the slot. You may need to gently wiggle the module.

4.Install a new module or install the module cover.

5.Screw the two captive screws to hold the module in place.

Issued Mar-06 Communications 5-4