Emerson ROC827 Removing and Replacing End Caps, Removing and Installing Wire Channel Covers

ROC827 Instruction Manual

2.3.1 Removing and Replacing End Caps

Normal use and maintenance of the ROC827 does not typically require you to remove the end caps on the housing. Follow these procedures in case removal is necessary.

To remove the end caps:

1.Place the tip of a flat-blade screwdriver into the top pry hole of the end cap and loosen the end cap by pulling the handle of the screwdriver away from the backplane.

Note: The pry holes are located on the sides of the end caps.

2.Place the tip of a flat-blade screwdriver into the bottom pry hole of the end cap and loosen the end cap by pulling the handle of the screwdriver away from the backplane.

3.Pivot the front end cap away from the back edge of the housing.

To replace the end caps:

1.Align the back edge of the end cap on the housing.

2.Rotate the end cap towards the housing and snap the end cap into place.

2.3.2Removing and Installing Wire Channel Covers

Install the wire channel covers over the wiring channels once the wiring of the terminal blocks is complete. Wire channel covers are located on the front of the ROC827 housing.

To remove a wire channel cover:

1.Grasp the wire channel cover at both the top and bottom.

2.Start at the top or bottom and pull the wire channel cover out of the wire channel.

To replace a wire channel cover:

1.Align the wire channel cover over the wire channel, allowing unobstructed wire access.

2.Press the wire channel cover into place until it snaps.

Note: The tabs on the left side of the wire channel cover should rest in the slots on the left edge of the channel.

Issued Mar-06 Installation and Use 2-6