If you have forgotten your current password and cannot use your computer, follow these steps:
1.Turn off the computer and follow the instructions under “Changing the Jumper Settings” in Chapter 5 to disable the password function by setting jumper J2 to position A.
2. Turn on the computer. You do not see the Enter Password prompt.
3. When the Press <Del> to start SETUP prompt appears, press Del.
4.Highlight Run SETUP and press Enter. You see the SETUP menu.
Follow the instructions in Chapter 2 to either set a new password or select Not Installed (if you do not want to set a new password). Be sure to save your SETUP information when you exit the program.
5.Turn off the computer and follow the instructions under “Changing the Jumper Settings” in Chapter 5 to enable the password function by setting jumper J2 to position B.
6.If you do not have a hard disk, insert the Startup diskette in drive A. Turn on the computer.
If you set a new password, you see the Enter Password prompt. Enter the password to access your system. (See “Using the Password” in Chapter 3.)
D - 6 Troubleshooting