If you need to change any jumper settings, follow these steps:

1.Remove any option cards that may be blocking your access to the jumpers. See page 5-16 for instructions.

2.Change the jumper settings.

3.Replace any option cards you removed. See “Installing an Option Card” on page 5-12.

4.Follow the instructions on page 5-40 to replace the computer’s cover.

Replacing the Battery

Your computer comes with a 3.6 volt lithium battery that provides power for the real-time clock and the CMOS RAM. The real-time clock keeps track of the time for your computer, and the CMOS RAM stores the information about your system configuration that was saved by the SETUP program.

This battery lasts approximately three to five years. If it loses power, you will see an error message when you turn on or reset your computer. Contact your dealer to obtain a replacement battery pack. Your dealer can also install the battery for you. If you want to replace the battery yourself, you can follow the instructions in this section.

Note

When the battery runs out, your computer loses the information stored in the CMOS RAM and the time stored in the real-time clock. After you replace the battery, you must run the SETUP program to reconfigure your system and set the real-time clock.

5-8Installing and Removing Options