There are two ways to reset the computer:

3If you are using MS-DOS, hold down Ctrl and Alt and press the Del key. The screen goes blank for a moment and then the computer should reload MS-DOS. If it doesn’t, try the next method.

QPress the RESET button on the front panel. This method works even when the computer does not respond to your keyboard entries.

If resetting the computer does not correct the problem, you probably need to turn it off and reboot it. Remove any diskette(s) from the diskette drive(s). Turn off the computer and wait five seconds. If you do not have a hard disk, insert the Startup diskette in drive A. Then turn on the computer.

Using a Password

If you set a password when you ran the SETUP program, you must enter it every time you turn on the computer or press the RESET button. Follow these steps to use your password:

1.If you do not have a hard disk, insert your Startup diskette in drive A.

2.Turn on the computer or press RESET. After the computer completes its memory test, the screen displays the following prompt:

Enter Password :

3.Type your password at the prompt. The screen does not display the characters you type. Then press Enter.

After you type the password correctly and press Enter, you see the Press <Del> to start SETUP prompt. If you do not press Del, the computer loads MS-DOS and displays the MS-DOS command prompt.

Using Your Computer 3-5