6.3 LUBRICATION AND ADHESIVES
The printer must be lubricated properly when it is disassembled for component replacement, or if mechanical
noise exceeds a certain level. EPSON recommends only the lubricants listed in the table below for this
printer, both of which have been tested extensively and comply with the requirements of this printer
mechanism. Figure 6-1shows the lubrication and adhesive points.

Table 6-1. Recommended Lubricants

Type Name Quantity Part No. Availability
Oil O-5 40 cc 1010513 E
Grease G-20 40 gm B700000001 E
G-36 40 gm B703600001 E
Adhesive Neji Lock #2 (G) 1000 g B730200200 E

Note: E = EPSON Exclusive product (Not commercially available)

Table 6-2. Lubrication and Adhesive Points

Ref. No. Lubrication/Adhesive Point Lubricant
1 The teeth of gear 60 G-36 (1-3 mg)
2 The teeth of combination gear 10, 50 G-36 (1-3 mg)
3 End point of shaft securing sub frame assembly G-36 (1-3 mg)
4 Cutout for the CR motor in the base frame assembly (2 points) G-36 (1-3 mg)
5 Shaft located in the center frame assembly G-36 (1-3 mg)
6 Shaft located in the center frame assembly G-36 (1-3 mg)
7 Surface of the eject roller assembly
8Contact surface of the right sideof the front paper guide and the
eject roller assembly G-36 (1-3 mg)
9Right end point of the eject roller assembly G-20(1-3 mg)
10 Contact surfaces of the shaft and combinationgear 13.5, 22 and
the combination gear holderon the sub frame assembly G-36(1-3 mg)
11 Theteeth of gear 22.5 G-36 (1-3 mg)
12 Theteeth of combination gear 28, 17.5
14 Endpoints of the pump speed-up shaft (both sides) G-36 (1-3 mg)
16 Cutpoint for knob on the right main frame G-36 (1-3 mg)
17 Contact points of gear 60, the platenroller shaft, and the PF cap
spring. G-36 (1-3 mg)
18 2points on the combination gear holder. G-36 (1-3 mg)
19 Oilpad on the carriage O5 (1-3 mg)
20 Contactsurface of gear 25 and the plain washer G-36 (1-3 mg)
21 Contactsurface of the platen shaft bushing and plain washer G-36 (1-3 mg)
22 Cutoutin the platen roller shaft G-20 (1-3 mg)
27 Contactpoint of the pressure spring and washer G-36 (1-3 mg)
28 Combinationgear 13.5, 22 G-36 (1-3 mg)
30 Theteeth of gear 24 G-36 (1-3 mg)
(1) Angularspacer for the black head and the cartridge base Neji Lock #2
(1-3 mg)
(2) Angularspacers for the color head and the cartridge base Neji Lock #2
(1-3 mg)
(3) The screw and washerattaching the ink cartridge holder to the
carriage base. Neji Lock #2
(1-3 mg)

Stylus Pro Service Manual Maintenance

Rev.A 6-3