Adjusting the Height of Your Image

If the image is too low, you can raise it by extending the projector’s feet.

1.Stand behind the projector. Pull up the blue foot release levers and lift the front of the projector. This unlocks the feet.

2.Once the image is positioned where you want it, release the levers to lock the feet in position.

3.To fine-tune the height of the image, rotate the thumb wheels attached to the projector’s feet.

If the image is no longer square after raising it, see the next section.

caution

Do not hold the projector by the lens; this can damage it.

Adjusting the Image Shape

If the projected image isn’t square or has a “keystone” shape, do one or more of the following:

■If your image looks like or , you’ve placed the projector off to one side of the screen, at an angle. Move it directly

in front of the center of the screen, facing the screen squarely.

■ If your image looks like

or

, press the + or — side of

Keystone

the Keystone button to correct the shape of the image. After

 

 

 

 

 

 

 

 

correction, your image will be slightly smaller.

 

 

 

 

 

 

 

 

You can also perform electronic keystone correction using the projector’s Setting menu. See page 53.

Using the Projector 27