caution
When replacing batteries, take the following precautions:
■Don’t mix old and new batteries.
■Replace batteries as soon as they run out. If the batteries leak, wipe away battery fluid with a soft cloth. If fluid gets on your hands, wash them immediately.
■Remove batteries if you won’t be using the remote control for a long time.
Power
Freeze
A/V Mute
R/C ON
3switch
2 | 4 |
1 | 5 |
| Enter |
light
Esc
button
Installing the Batteries
Follow these steps to install the remote control’s batteries:
1.Press the tab to release the battery compartment cover.
tab
2. Remove the cover and insert the two AA batteries included with the projector as shown.
3. Replace the battery compartment cover.
Before you can use the remote control, you need to turn it on as described below.
Turning On the Remote Control
Make sure the batteries are installed. Then push up the on/off switch on the side of the remote control to turn it on.
If you want to make sure the batteries are good, press the round 
light button. The other buttons on the remote should light up
temporarily. If they don’t, you need to change the batteries as described above.
Turn off the remote control before transporting it or storing it with the projector in a carrying case; this prevents the batteries from discharging if something presses against one of the remote control’s buttons.
32Using the Remote Control