User's Logo Capture

Set the zoom rate.

zoom rate :

100 200 300

:Return :Select :Execute

You see the screen shown at the left.

6.Use the arrow buttons on the control panel or the Enter button on the remote control to select a zoom rate (display size), and then press Enter.

7.When the message “Do you save the user’s logo?” appears, select Yes and press Enter.

Saving the logo may take a few moments. Do not use your projector or video source (computer, DVD player, etc.) while the logo is being saved.

8.When you see the message “Saving the user’s logo is completed,” press Esc to return to the menu screen.

note

You can also set up your image as the startup screen using the Advanced menu; see page 54.

Choosing When to Display the Image

After your image is saved, you can set it up as the no-signal message and/or the screen that’s displayed when you press the A/V Mute button.

1.Press the Menu button to display the menu screen (if not already displayed).

2.Press the down arrow (control panel) or press down on the Enter button (remote control) to highlight the Setting menu.

3.Press the Enter button to select the Setting menu.

4.Press the down arrow (control panel) or press down on the Enter button (remote control) to highlight either No-Signal Msg. or A/V Mute, depending on when you want the image to display.

5.Press the right arrow or use the Enter button to select Logo. This sets your image as the screen to be displayed.

6.When you’re finished, press Esc to exit the menu system.

52Fine-tuning the Projector