32
Preventing theft (Password Protect)
User’s Guide
The password entry screen will not be displayed at all when the power is
turned on until the length of time that has been set has elapsed. When the
set length of time has elapsed, the password entry screen will be displayed
each time the power is turned on. The length of time referred to here is the
total illumination time for the projector's lamp from the point when the
projector's menu is closed.
If "Timer" is set to "0", the password entry screen will be displayed each
time the power plug is disconnected and reinserted from the electrical
outlet. If the projector is powered on when it is in standby mode, the
password entry screen will not be displayed.
If an attempt is made to carry out any of the following user logo
operations, a message is displayed and the setting cannot be changed. To
change the setting, set "User’s Logo Protect" to "OFF" first. sp.33
• Capturing a user's logo
• When the " Extended" - "Display" - "Background Color" menu setting is
changed from "Logo" to "Black" or "Blue", or changed from "Black" or
"Blue" to "Logo".
• When the "Extended" - "Display" - "Startup Screen" menu setting ("ON"
or "OFF") is changed.
Setting Password Protect
Use the following procedure to set Password Protect.
PROCEDURE

Hold down the [Freeze] button for approximately 5

seconds.

The "Password Protect" menu will be displayed.

This can also be displayed by pressing the [Menu] button while

holding down the [ ] button continuously for about 5 seconds.

If the "Timer" Setting is for One Hour or More

When "User’s Logo Protect" is enabled (ON)

1
Remote control
TIP
•If Password Protect has already been enabled, the Password screen
will be displayed.
If the password has been entered correctly, the "Password Protect"
menu will be displayed.
"When Password Protect is enabled" sp.31
•If Password Protect is set to "ON", attach the accessory Password
Protect sticker to your preferred position on the projector as a theft-
prevention measure.