42
Adjusting the Screen Image
User’s Guide
PROCEDURE
While pulling the foot adjust lever at the front of the
projector, lift up the front of the projector to extend the
front adjustable foot.
Extend the front adjustable foot until the desired angle is obtained,
and then release the foot adjust lever.
To retract the front adjustable foot, gently push down on the projector
while pulling the foot adjust lever.
If you tilt the projector up, keystone distortion will occur in the projected
screen. However, the projector is equipped with an automatic keystone
correction function that can automatically correct this keystone distortion
on the screen. Automatic keystone correction is carried out approximately
one second after the projector is tilted vertically while the power is on.
Foot adjust lever (Front)
TIP
When the projector is tilting horizontally, turn the left rear adjustable
foot until the projection is level. When the projector is tilted
horizontally, the correction may not be carried out correctly. sp.42
Extend Retract
Rear
adjustable foot
TIP
•Automatic keystone correction is not carried out when the
"Projection" command in the "Extended" menu is set to "Front".
•If you would like to make further fine adjustments after automatic
keystone correction has been carried out, press the [ ] and [ ]
buttons on the projector's control panel. sp.43
•When keystone correction is carried out, the projected image will
become smaller.
•If the text part of the image is blurred after keystone correction is
carried out, decrease the sharpness setting.
s
p.56, p.58
•If automatic keystone correction is not required, set "Auto
Keystone" in the "Setting" menu to "OFF". sp.62