88
Problems Solving
User’s Guide
The fans do not stop when power is turned off (EMP-765/755 only)
Mail notification messages are not being sent when a problem occurs with the projector
Check Remedy
Is the "Standby Mode" configuration menu set
to "Network ON"?
If the menu is set to "Network ON", the fans will continue to operate after the cool-down period has
finished.
"Extended" - "Standby Mode" sp.66
Problems Relating to Monitoring and Controlling Projectors Using a Network (EMP-765/755 only)Check Remedy
Is the wireless or wired LAN card inserted? Check that the wireless or wired LAN card is correctly inserted into the card slot of the projector.
"Inserting and Removing Cards" sp.17
Is the network cable connected correctly? Check that the network cable is connected correctly. If it is not connected or is connected
incorrectly, reconnect it.
Are the settings for connecting to a network
correct?
Check the network settings for the projector.
s"Connecting in Access Point Mode or Wired LAN Mode" in the EasyMP Network Setup Guide
Has "Standby Mode" been set to "Network
ON"?
If using the mail notification function while the projector is in standby mode, change the "Standby
Mode" menu setting to "Network ON". "Extended" - "Standby Mode" sp.66
Has a critical problem developed causing the
projector to momentarily stop working?
When the projector has momentarily stopped working, it cannot send e-mail messages. If the
projector cannot be reset even after it has been checked, contact your dealer or the nearest address
provided in the "International Warranty Conditions" section of the Safety Instructions/World-Wide
Warranty Terms booklet.
Is power being supplied to the projector? Check if the power supply to the location where the projector is set up has been interrupted, or if the
circuit breaker for the electrical outlet that the projector is connected to has been tripped.
When connected to a wired LAN