89
Problems Solving
User’s Guide
The projector cannot be monitored and controlled using the EMP Monitor function
When Network Screen is running, the current image stays projected and connection from another computer is not possible
Check Remedy
Is the wireless or wired LAN card inserted? Check that the wireless or wired LAN card is correctly inserted into the card slot of the projector.
"Inserting and Removing Cards" sp.17
Is the network cable connected correctly? Check that the network cable is connected correctly. If it is not connected or is connected
incorrectly, reconnect it.
Are the settings for connecting to a network
correct ?
Check the network settings for the projector.
s"Connecting in Access Point Mode or Wired LAN Mode" in the EasyMP Network Setup Guide
Has EMP Monitor function been correctly
installed to the computer?
Uninstall EMP Monitor and then re-install it.
s"If You would like to Uninstall the EasyMP Software" and "Installing EasyMP Software" in the
EasyMP Network Setup Guide
Have all projectors that are to be monitored
and controlled been registered in the
projector list?
Register the projector in the projector list. sEMP Monitor Operation Guide
Has "Standby Mode" been set to "Network
ON"?
If using the EMP Monitor function while the projector is in standby mode, change the "Standby
Mode" menu setting to "Network ON". "Extended" - "Standby Mode" sp.66
Is power being supplied to the projector? Check if the power supply to the location where the projector is set up has been interrupted, or if the
circuit breaker for the electrical outlet that the projector is connected to has been tripped.
Check Remedy
Has the person making the presentation left
the meeting room without closing the
connection?
If you try to connect to a projector from a computer while Network Screen is running and the
projector is already connected to another computer, the connection to the first computer will be
terminated and the projector will then connect to the next computer.
If no projector keyword has been set in the projector or the keyword is known, it is possible to
terminate the current connection and connect to the projector by establishing a new connection from
the computer.
If a projector keyword has been set in the projector and the projector keyword is unknown, terminate
the connection from the projector and then reconnect. To terminate the connection from the
projector, press the [Esc] button on the remote control, select the "Exit" button from the displayed
menu and then press the [Enter] button on the remote control. Connect from the desired computer
after terminating the connection.
s"Disconnecting from a Network Connection" in the EasyMP Network Setup Guide
When connected to a wired LAN