2.Turning the stitch side downward, spread the paper basket on the floor.
3.Holding the rear shaft, pass it under the horizontal struts.
4.Rotate the rear paper basket joints to enfold the bar that is not attached to the fabric. Insert the stanchion pins into the holes on the base upright left and right, as shown.
5.Slide out the upper basket hooks to their full length.
6.Hook both ends of the center shaft (O) on the upper basket hooks.
O 
7.Insert the lower shafts into the holes on the bottom of the base unit as shown below.
8. Stand the lower shafts.
9.As shown in the figure, hook the paper feed support film on the shaft of the paper basket (the movable hook (a) on the intermediate shaft and the stability hook (b) on the back shaft), so that it hangs along the inner surface of the basket.
10