11.Press the Pause button.

The printer heads move and the paper automatically feeds into the printing position. READY appears on the LCD panel.

Note:

Even if you do not press the Pause button, the print heads move and paper feeds into the printing position automatically. READY appears on the LCD panel.

Now you are ready to print on roll paper. Make the printer driver settings, then send the print job. (See the User’s Guide for detailed informations).

Note:

❏Allow time for the ink to dry thoroughly after printing to ensure the printout quality.

❏If you do not use the paper set above, remove it from the printer. When you use roll paper, set the paper lever to the released position, and wind it up. When you use cut sheet, remove the paper from the printer and store it separately.

Loading the Cut Sheet Media

To load cut sheet media longer than 483 mm (long edge of Super A3/B), see the next section. To load paper with a length of A4, Letter, A3, US B, and Super A3/B, see “Loading Cut Sheet Media with a Length of A4/Letter, A3/US B, and Super A3/B” on page 22.

If you are printing on thick paper (0.5 to 1.5 mm), see “Printing on Thick Paper (0.5 to 1.5 mm)” on page 23.

Loading Cut Sheet Media Longer than 483 mm (Long Edge of Super A3/B)

To load cut sheet media longer than 483 mm, follow the steps below.

cCaution:

As much as possible, keep your fingers off the printable surface of the media, as fingerprints may reduce printout quality.

1. Make sure that the printer is on and the roll paper cover is closed.

2.

Press the Paper Source l button repeatedly

English

 

 

until Sheet

appears.

 

3.

Make sure that the Power light is not flashing,

 

 

and then set the paper lever to the released

 

 

position. The LEVER RELEASED. LOAD PAPER

 

 

 

 

appears on the LCD panel.

 

cCaution:

Do not set the paper lever to the released position while the Power light is flashing; otherwise, damage may occur.

4.Load the sheet into the paper insertion slot until it comes out below. Make sure that the right and bottom edges of the sheet are straight and in line with the horizontal line and the vertical line.

5.Set the paper lever to the secured position. PRESS PAUSE BUTTON appears on the LCD panel.

21