Setting up the Printer

Connecting the Power Cord

Note:

Most illustrations shown in this section are for EPSON Stylus Pro 9800/9400, so they may vary in appearance from EPSON Stylus Pro 7800/7400. The instructions are the same, except as noted.

1.Check the label on the back of the printer to make sure the voltage required by the printer matches that of the wall outlet. Also, make sure that you have the correct power cord for your power source.

c Caution:

It is not possible to change the printer’s voltage. If the rated voltage and your outlet voltage do not match, do not plug in the power cord, and contact your dealer for assistance.

2.Connect the power cord to the AC inlet on the back of the printer.

3.Route the power cord through the clamps at the rear of the printer. The cord can be routed to either the left or right side.

4.Plug the power cord into a properly grounded electrical outlet.

c Caution:

Do not use an outlet that is controlled by an automatic timer or wall switch. Otherwise, accidental shut down or damage to your printer may occur.

Installing the Ink Cartridges

To install the ink cartridges, follow the instructions below.

wWarnings:

The ink cartridges are self-contained units. Under ordinary use, ink will not leak from the cartridges. If ink does get on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water.

Note:

❏The ink cartridges included with your printer are primarily for initial setup. Because your printer will use large quantities of ink during the setup process, you may need to replace the ink cartridges soon.

❏Initial ink charging requires approximately 10 minutes.

English

17