Epson E02 manual Setting the IP Address Using the arp/ping Command

UB-E02 Technical Reference Guide

3.1.2 Setting the IP Address Using the arp/ping Command

You can set the IP Address using the arp/ping command. This way of setting is available with the host, which is in the same segment as that of the UB-E02.

CAUTION:

When setting the IP address of the UB-E02, do not use the same IP addresses as that of other network devices or PCs.

Here is an example of setting the IP address to 192.168.100.201.

❏You will set the gateway address to the computer in which you will input the arp/ping command.

❏If a server or router acts as a gateway, type the gateway address.

❏If there is no gateway, type the IP address of your computer.

❏If you do not know the gateway address, ask your network administrator for it.

Note:

The IP address cannot be set without setting the gateway address.

1.Connect the printer with the UB-E02 installed to the network and turn on the printer.

2.Execute the commands as described in the following steps.

Note:

Be sure to execute the commands within 2 minutes. After 2 minutes, you must restart the commands from the beginning.

3.Make the connection between the IP address which you want to set and the MAC address of the UB-E02 by executing an arp command.

•From the command line, type: arp-s [IP address] [MAC address]

Example using DOS: arp-s 192.168.100.201 00-00-48-83-00-00

Example using UNIX: arp-s 192.168.100.201 00:00:48:83:00:00

CAUTION:

When the UB-E02 is installed on the printer and the MAC address on the label on the UB-E02 cannot be seen for sure, turn off the printer and then remove the UB-E02 to confirm it.

Note:

The MAC address can be found on the status sheet or a label on the UB-E02. For printing the status sheet, refer to the Initializing UB-E02 and Status Sheet Printing section in Chapter 2.

Rev. A Utilities 3-11