Cleaning the Print Head

Running the Cleaning Cycle

To run the cleaning cycle, follow these steps:

1.Make sure the printer is off line. If the ON LINE light is on, press ON LINE to set the printer off line.

2.Open the printer cover. Then press SelecType to enter SelecType mode. The SelecType light goes on.

3.Press CLEANING briefly. Then release the printer cover support and close the printer cover. The display reads CL, the print head cleaning message, and the printer runs the cleaning cycle.

4.If print quality problems persist, repeat the previous four steps to run the cleaning cycle again.

Note: If there is paper in the paper path when you try to run the cleaning cycle, the printer will not perform the entire cycle (the print head will not move to the right for brush cleaning).

Maintenance and Transportation 5-5