5.Slide the left sprocket
approximately
0.5 inch (12 mm) from the far left position and pull the blue lever forward to lock it in place. Then slide the right sprocket to match the width of your paper, but do not lock it.
6.Remove the front cover by pulling it straight down.
10
5
0
7.Make sure your paper has a clean, straight edge. Then open both sprocket covers and fit the first four holes of the paper, with the printable side up, over the tractor pins.
8.Close the sprocket covers.
9.Slide the right sprocket to remove any slack in the paper; then lock it in place by pushing the sprocket lock down.
20Paper Handling