Adjusting the top-of-form position
The top-of-form position is the position on the page where the printer starts printing. If your printing appears too high or low on the page, you can use the Micro Adjust function to adjust the top-of-form position, as described below. Your top-of-form position setting remains in effect until you change it, even if you turn off the printer.
cCaution:
Never use the knob to adjust the top-of-form position; this may damage the printer or cause it to lose the top-of-form position.
1.Make sure the printer is turned on.
2.Load paper. (If the tractor is in a push position, press the Load/Eject button to advance continuous paper to the current top-of-form position.) If necessary, lift the printer cover so you can see the paper position.
3.Hold down the Pause button for three seconds. The Pause light flashes and the printer enters Micro Adjust mode.
4.Press the LF/FF D button to move the top-of-form position up on the page, or press the Load/Eject U button to move the top-of-form position down on the page.
5.Press the Pause button to exit Micro Adjust mode.