Loading Continuous Paper with the Pull Tractor

1.Make sure the printer is turned off, and the printer cover is removed. Also make sure the tractor is installed in the pull position and the paper guide is lying flat on the printer. (You may need to move the tractor from the rear push or front push position.)

2. Set the paper release lever to the pull tractor position.3.Release thesprockets by pulling the sprocket lock levers forward.4.Slide the leftsprocket

approximately

Edge guides

 

0.5 inch (12 mm)

 

from the far left

 

position and push

 

the lever back to

 

lock it in place.

 

Then slide the right sprocket to match the width of your paper, but do not lock it.

Slide the edge guides to the center.

5.Make sure your paper has a clean, straight edge. Then open the sprocket covers.

Note:

Make sure the printer is off before you insert the paper in the paper slot. If you insert the paper while the printer is on, a paper jam may occur.

Paper Handling

23