4.Slide the left sprocket
approximately 0.5 inch (12 mm) from the far left position and push the blue lever back to lock it in place. Then slide the right sprocket to match the width of your paper, but do not lock it.
The triangle mark on top of the printer indicates the point furthest to the left where printing can begin.
5.Make sure your paper
has a clean, straight edge. Then open both sprocket covers and fit the first four holes of the paper, with the printable side down, over the tractor pins.
6.Close the sprocket covers. Then slide the right sprocket to remove any slack in the paper and lock it in place by pushing the blue lock lever down.
7.Attach the paper guide and lay it flat on the printer. Slide the edge guides to the middle of the paper guide.
8.Turn on the printer. When the printer receives data, it automatically loads the paper and starts printing.
If the first line on your page appears too high or low, change its position with the Micro Adjust function. (See page 33.)
cCaution:
Never use the knob to adjust the
22Paper Handling