| Troubleshooting | |
A B black or A color ink out light is flashing or on | ||
|
| |
Possible cause | Solution |
|
If flashing, the ink supply is | You need to replace the indicated ink cartridge soon. Make sure |
|
getting low. | you have a new cartridge, then see page | |
|
|
|
If on, the ink cartridge is | You must replace the indicated ink cartridge; see page | |
empty. | instructions. | |
|
| |
The S and P lights are flashing | ||
|
| |
Possible cause | Solution |
|
A carriage error has | Remove any paper in the printer. Press the E load/eject button for |
|
occurred. | about 30 seconds. Then press it again. Turn the printer off, wait a | |
| few seconds, and then turn it on and try printing again. If the error | |
| is not cleared, contact EPSON as described in the Introduction. | |
|
| |
All the lights are flashing | ||
|
| |
Possible cause | Solution |
|
|
|
|
You haven’t removed all the packing material from the printer.
Remove the packing material, following the instructions on the Notice Sheet in the box.
An internal error may have occurred.
Turn off your printer, wait a few seconds, and turn it on again. If the lights still flash or stay on, contact EPSON as described in the Introduction.
The printer has finished charging the ink cartridge, but the P power light is still flashing
Possible cause | Solution |
The ink cartridge clamp isn’t | Press down on the clamp to lock it into place. |
locked down. |
|
|
|
Packing material remains in | Remove the packing material, following the instructions on the |
the printer. | Notice Sheet in the box. |
|
|
The printer needs to | If the printer is not moving or making noise, but the light is still |
initialize. | flashing after 5 minutes have passed, turn the printer off. If the |
| light is still flashing when you turn it back on, contact EPSON as |
| described in the Introduction. |
|
|
The printer may be receiving data from the computer.
Turn the printer and computer off. Disconnect the printer from the computer. Turn the printer on. If the light continues to flash for more than 5 minutes, contact EPSON as described in the Introduction.