
Error messages
If an error occurs in operation, or if an operation could not be processed correctly, and error message will appear. Refer to the displayed error message and take the appropriate action.
Aborted Command
Illegal Request
Situation: This disk drive cannot be used by the
Already Selected
Situation: The currently selected disk drive was selected.
Action: If you wish to switch to another disk drive, re- select the disk drive.
Arbitration Fail
Busy Status
Check Condition
Status Error
Wait For BUSS Free
Situation: Normal communication with the disk drive could not be accomplished.
Action: Make sure that the disk drive is connected cor- rectly.
Can’t Communicate
Drive Time Out
Message Error
Phase Mismatch
Undefined Sense
Unit Attention
? Unknown Error
Situation: There is a problem with the connections to the disk drive.
Action: Make sure that the disk drive is connected cor- rectly.
Can't Recover
Situation: The drive check Recover procedure could not be executed because there was insufficient free space on the disk.
Action: Delete unneeded songs. Alternatively, perform the Song Optimize procedure.
Digital In Unlock
Situation 1: A digital signal is not being input to the DIGI- TAL IN connector.
Action 1: Press [YES], and then make sure that power of the digital equipment is turned on and that the digital equipment is connected correctly.
Situation 2: The sample rate specified for the song is differ- ent than the sample rate of the digital device connected to the DIGITAL IN connector.
Action 2: Press [YES], and set the sample rates of both devices to match.
Disk Memory Full
Situation 1: There is insufficient free area on the disk.
Action 1: Erase unneeded data. Or, select a different disk drive.
Situation 2: The maximum number of songs that can be recorded on a disk drive (200) has been exceeded.
Action 2: Delete unneeded songs. Or, select a different disk drive.
Disk Write Error
Situation: An error occurred while writing data to the disk drive.
Action: The song data has not been correctly saved to disk. Back up the song data to a DAT recorder, initialize the disk drive, and restore the backed up song data to the disk drive.
Drive Too Slow
Situation 1: If this message appears when you first begin using a disk drive with the
Action 1: When using this disk, create a new song with a lower sample rate or recording mode, and record using this song.
Situation 2: If this message appears after you have been using the disk drive with the
Action 2: Either use the track bouncing operation to re- record playback data to another track, or use the optimize operation. If the same message appears even after these measures have been taken, copy the song data to another disk drive and initialize the disk drive that produced the problem.
Event Mem Full
Situation: The
Action: Delete unneeded auto mix data. Alternatively, perform the Song Optimize operation.
MarkerMemory Full
Situation: The
Action: Delete unneeded Marker.
Hardware Error
Situation: There is a problem with the disk drive.
Action: Contact the manufacturer or dealer of the disk drive.
Medium Error
Situation: There is a problem with the disk drive media.
Action: This disk cannot be used by the