Chapter 4 Editing a recorded performance (track editing)
Example 2: Moving to a different track
B
B
Start | End | To | Time |
Example 3: Moving using the “Frm” setting
C
C
Start From | End | To | Time |
*If playback data exists at the move destination, that data will be overwritten.
*Playback data of a channel for which Channel Link is ON cannot be moved to a track whose channel has a Channel Link setting of OFF. Nor is the converse possible.
*The length of the data to be moved must be greater than 0.5 seconds. If data shorter than 0.5 seconds is moved, the sound will not playback.
*Do not leave sound within 0.5 seconds before or after the section of data that is moved. Any sound which was within 0.5 seconds of the moved data will not playback.
1.Select the
2.Press [TRACK], select “TRK Track Move?,” and press [YES]. The display will let you select the move source track, and the move destination track and
|
|
|
|
| Move source | Move destination | |||||
|
|
|
|
| (Track – V track) | (Track – V track) | |||||
CONDITION MARKER# |
|
| TIME |
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
dB
0
4
12
24
48
INPUT TRACK | AUX MASTER |
3.Use [SEL (CH EDIT)] to select the move source track. When the move source track is selected, the 
] to make the move destination field blink, use [SEL (CH EDIT)] to select the move destination track, and use the TIME/VALUE dial to select the move destination
If you wish to perform a move operation with the same settings for other tracks, select the move source and move destination tracks, and press CURSOR [ 
] once again. Now you can specify the new move source and move destination tracks. In this case, it will not be pos- sible to select move destination tracks that have already been selected as move source tracks.
If you wish to cancel the move operation for a track, use PARAMETER [ 
][ 
] to display the settings for that track, and press [CANCEL (NO)] twice.
4.Set the following items, and execute the copy opera- tion.
St (start point): Specify the starting time of the move source playback data.
End (end point): Specify the ending time of the move source playback data.
Frm (from point): Specify the time of the move source playback data that will cor- respond to the To point. Normally you will set this to be the same as the Start point.
To (to point): Specify the base time of the move destination.
< An easy way to specify the time settings >
Times for the Start point, From point, End point and To point can be specified directly without having to display the Track Move page. In Play condition, use the following procedure.
1.Move to the beginning (Start point) of the move source performance data.
2.Hold down [TRACK] and press [LOC1/5].
3.Move to the time location in the destination to which the performance data will be moved (From point).
4.Hold down [TRACK] and press [LOC2/6].
5.Move to the end location of the performance data that is being moved (End point).
6.Hold down [TRACK] and press [LOC3/7].
7.Move to the basic time of the move destination (To point).
8.Hold down [TRACK] and press [LOC4/8].
If you now access the Track Move page, the times that were specified in steps 1Ð8 will be input as the time set- tings for the respective points.
80
