
Chapter 1 Trying out the expanded functions
Chapter 1
Display related
■Holding the level meter peaks
When the bar display (p.114) is the level meter, you can now cause the maximum volume value (peak) to remain (be held) in the display.
CONDITION MARKER# | TIME |
RemainDsp (Remaining display)
Specify how the remaining disk capacity will be displayed.
Time: Displayed as recording time (minutes/sec- onds) (same as Ver.1).
CapaMB: Displayed as actual capacity (MB).
Capa%: Displayed as percentage (%) of capacity of the entire disk.
Event: Displayed as the number of events used for recording.
dB
0
4
12
24
48
INPUT TRACK | AUX MASTER |
1.Press [SYSTEM] several times until “SYS System PRM?” appears.
2.Press [YES].
3.Press PARAMETER [ ] several times until the dis- play indicates “SYS PeakHoldSw=”.
CONDITION MARKER# | TIME | ||||
|
|
|
|
|
|
dB
0
4
12
24
48
INPUT TRACK | AUX MASTER |
4.Rotate the TIME/VALUE dial.
PeakHoldSw (Peak hold switch)
When Pre Level or Post Level is displayed in the bar dis- play, you can specify whether the peaks will be held.
OFF: Peaks will not be held (same as Ver.1).
ON: Peaks will be held.
5.Press [PLAY(DISPLAY)].
You will return to Play condition.
To reset the peak display, press [PLAY(DISPLAY)].
5.Press [PLAY(DISPLAY)].
You will return to Play condition.
■Checking the remaining disk
capacity
The REMAINING TIME column indicates the approximate time (capacity) remaining for recording in the current song. You can now specify the type of this display.
1.Press [SYSTEM] several times until the “SYS System PRM?” display appears.
2.Press [YES].
3.Press PARAMETER [ ] several times until the “SYS RemainDsp=” display appears.
4.Rotate the TIME/VALUE dial.
37