Placing 35-mm Slides in the Holder

1.Fit the holder’s tabs into the two small holes at the rear edge of the glass. Make sure the cutouts for 35-mm slides are in the middle of the glass (not at the rear edge) to align them with the fluorescent lamp when you close the lid.

Fluorescent lamp

Cutouts for slides are in middle of glass

2. Place your slides in the film holder as shown.

Note:

The photos should be mirror-imaged when viewed from overhead. (The shinier side faces down; the duller side faces up.)

To avoid unnecessary cropping of your photos, always place your slides with the wider part of the film width-wise on the glass (in landscape orientation).

Continue with the steps on page 18 to scan and print your photos.

16Copying