Placing 35-mm Film Strips in the Holder

1. Remove the film strip cover.

2. Slide your film strip into the holder.

Note:

The photos should be mirror-imaged when viewed from overhead. (The shinier side faces down; the duller side faces up.)

3.Replace the film strip cover.

4.Fit the holder’s tabs into the two small holes at the rear edge of the glass. Make sure the film strip is in the middle of the glass (not at the rear edge) to align it with the fluorescent lamp when you close the lid.

Fluorescent lamp

Film strip is in middle of glass

Continue with the steps in the next section to scan and print your photos.

Making Prints From Slides or Negatives 17