Projector Care

Replacing the lamp

• Wait until the lamp has cooled down sufficiently before opening the c lamp cover. It takes one hour after the projector’s cool-down period has

finished for the lamp to be cool enough.

When the lamp is broken, replace it with a new lamp, or contact your dealer for further advice. If replacing the lamp yourself, be careful to avoid pieces of broken glass.

1Turn off the projector and wait for the cool-down period to end. (Approximately 20 seconds)

2Unplug the power cable and remove it, then wait for the lamp to cool down. (Approximately 1 hour)

3Open the lamp cover.

Push in the tabs on the lamp cover and push it up to remove it.

57

4Loosen the screws holding the lamp in place.

5Remove the old lamp.

6Install the new lamp.

Press the lamp until it clicks into place, then tighten the two screws.