Epson Series II Connecting the Monitor to Your Computer

Alternatively, you can purchase your own video interface cable and connect it to the monitor’s BNC connectors. See the BNC connector signals table on page 54 to determine which video interface cable(s) and BNC connectors to use with your system.

If your computer or video adapter card does not have a VGA connector, you cannot use the video interface cable that comes with the monitor. Determine the sync requirements of your video controller, see the BNC connector signals table on page 54, if necessary, and purchase the appropriate interface cable(s). Consult your dealer if you need help. Then connect the interface cable(s) to the appropriate connector(s).

Connecting the Monitor to Your Computer

Before you connect the monitor to your computer, you need to make sure your computer and/or video adapter card is set up for use with the monitor. If necessary, install an appropriate video adapter card in your computer and set any DIP switches or jumpers on the card to match the monitor. You may also need to change jumper settings inside the computer. See your computer and/or video adapter card manual for instructions.

Note

If you want to connect two or more monitors to one video controller, see page 10 for instructions.

Follow these steps to connect the monitor to your computer:

1.Before you connect any cables, make sure the monitor, computer, and all other peripheral devices are turned off. The monitor is off when the power button on the left side of the control panel extends out from the panel, as shown in the following illustration.

6 Professional Series II Monitor