Note

If you are connecting only one monitor to the video interface, make sure the HIGH/75SZ switch is set to 75Q (the factory setting). As long as you use only one monitor with your computer’s video controller, do not set the HIGHi75Q switch to HIGH because this causes excessive brightness and lowers the resolution.

3.Plug one end of the video interface cable that comes with the monitor into the VGA connector labeled D-SUB INPUT and tighten the screws on the cable connector.

4.Plug the other end of the video cable into the video interface on your computer and tighten the connector screws. (See your computer and/or video adapter card manual for more detailed instructions.)

5.Plug the monitor’s power cord into the AC power inlet on the back panel and then into a grounded (earthed) electrical outlet. The monitor contains a universal (90 to 264 VAC) power supply, so you do not need to check the voltage of your power supply.

8 Professional Series II Monitor