Epson Series II Reducing Color Impurity

6.When you are satisfied with the shade of white you see, do not touch any control panel buttons for at least 30 seconds. After 10 seconds, the LCD displays the number of the current video mode or Mode not found. After 30 seconds, the monitor saves the color temperature you defined as color temperature 3.

7.Press MEM SEL twice to exit from defining a color temperature. After 10 seconds, the LCD displays the number of the current video mode or Mode not found.

Reducing Color Impurity

You can use the Degauss button (shown below) to minimize distortion and color impurity, such as colored spots on the screen, caused by magnetic fields. If you notice distortion or color impurity on your screen, electromagnetic interference is present. Press the Degauss button to improve the screen image.

Degauss button

To avoid electromagnetic interference, move any devices

Professional Series II Monitor

3 7

Contents

Page Page Page Page Page Page Page Page Introduction Page Where to Get Help Unpacking the Monitor Setting Up the Monitor Connecting the Monitor to Your Computer Page Page Page Connecting Two of More Monitors to One Video Controller Page Page Page Page Connecting three monitors Turning On the Monitor MEM SEL The Control Panel Page Setting the Type of Video lnput Adjusting the Brightness and Contrast Using Video Modes Page Page Modifying a Video Mode Page MEM SEL MEM STORE Recalling a Factory-setVideo Mode MEM RCL MEM RCL. You Creating a User-definedVideo Mode The Page Page Adjusting the Vertical and Horizontal Convergence If you press FUNCT when the LCD displays Page Selecting the Color Temperature Page Defining Your Own Color Temperature you want WARNING Reducing Color Impurity CIeaning the Monitor Troubleshooting The screen and the LCD do not come on The screen is blank and the LCD displays H/V SYNC OFF*, H sync OFF*, or v SYNC OFF The screen is blank and the LCD does not display a SYNC OFF error message There is an image on the screen but the LCD is dim The LCD displays Mode not found The image is not centered on the screen The image is too big or too small for the screen The image is fuzzy You want to change the shade of white on the screen There are colored spots on the screen or the image is distorted One of two colors are missing Additional error messages Factory-setVideo Modes Page Page Page Page Specifications Trinitron CRT Display Interfacing Requirements AC fine Voltage Environmental Requirements Reliability Safety Standards External Controls Adjustable Display Parameters Physical Characteristics Dimensions Tilt and swivel base lnferface Connectors