Epson Series II 21

5.Plug the VGA connector on the color-coded video cable into the computer’s VGA interface and tighten the connector screws.

6.Connect one 75Q video interface cable to each T connector on the first monitor, as shown below.

de0

ce cable

Tconnector

7.Then connect each 75Q video interface cable to the appropriate BNC connector on the second monitor. Connect the cable from the T connector labeled V to the BNC connector labeled V, the cable from the T connector labeled H/(HtV) to the BNC connector labeled H/(H+V), and so on. The illustration on the next page shows two monitors connected to the computer’s video interface.

Professional Series II Monitor 13

Contents

Page Page Page Page Page Page Page Page Introduction Page Where to Get Help Unpacking the Monitor Setting Up the Monitor Connecting the Monitor to Your Computer Page Page Page Connecting Two of More Monitors to One Video Controller Page Page Page Page Connecting three monitors Turning On the Monitor MEM SEL The Control Panel Page Setting the Type of Video lnput Adjusting the Brightness and Contrast Using Video Modes Page Page Modifying a Video Mode Page MEM SEL MEM STORE Recalling a Factory-setVideo Mode MEM RCL MEM RCL. You Creating a User-definedVideo Mode The Page Page Adjusting the Vertical and Horizontal Convergence If you press FUNCT when the LCD displays Page Selecting the Color Temperature Page Defining Your Own Color Temperature you want WARNING Reducing Color Impurity CIeaning the Monitor Troubleshooting The screen and the LCD do not come on The screen is blank and the LCD displays H/V SYNC OFF*, H sync OFF*, or v SYNC OFF The screen is blank and the LCD does not display a SYNC OFF error message There is an image on the screen but the LCD is dim The LCD displays Mode not found The image is not centered on the screen The image is too big or too small for the screen The image is fuzzy You want to change the shade of white on the screen There are colored spots on the screen or the image is distorted One of two colors are missing Additional error messages Factory-setVideo Modes Page Page Page Page Specifications Trinitron CRT Display Interfacing Requirements AC fine Voltage Environmental Requirements Reliability Safety Standards External Controls Adjustable Display Parameters Physical Characteristics Dimensions Tilt and swivel base lnferface Connectors