NOTE: Do not add any type of tire liner or foam fill material to the tires. Excessive loads created by foam filled tires may cause failures to the hydro drive system, frame, and other components. Foam filling tires will void the warranty.

5.1.16Check condition of belts:

Service Interval: 40 hrs.

a)Stop engine, wait for all moving parts to stop, and remove key.

b)Unhook seat latch and tilt seat up. Lift the rubber flap on front side of the engine to check pump drive belt.

c)Remove left and right belt shields on deck and lift up floor pan to inspect deck drive belt.

d)Check under machine to inspect the mule drive belt.

e)See Sections 5.2.3, through 5.2.5 for belt adjustment.

5.1.17Lubricate grease fittings:

Service Interval: Refer to chart.

a)Stop engine, wait for all moving parts to stop, and remove key.

b)Lubricate fittings with one to two pumps of NGLI grade #2 multi-purpose gun grease.

Refer to the following chart for fitting locations and lubrication schedule.

LUBRICATION CHART

 

FITTING

INITIAL

NO. of

SERVICE

 

LOCATIONS

PUMPS

PLACES

INTERVAL

1.

Front Caster wheel hubs

0

2

yearly

2.

Front Caster Pivots

0

2

yearly

3.

Height Adj. Shaft Bearings

1

5

40 hours

4.

Deck Drive Belt Idler Arm

 

 

 

 

For Units With S/N 464,999 and Lower

1

1

40 hours

 

For Units With S/N 465,000 and Higher

1

1

Yearly

5.

Brake Brackets

1

2

200 hours

6.

Mule Drive Belt Idler Arm

 

 

 

 

For Units With S/N 464,999 and Lower

1

1

40 hours

 

For Units With S/N 465,000 and Higher

1

1

Yearly

7.

Pump Drive Belt Idler Arm

 

 

 

 

For Units With S/N 464,999 and Lower

1

1

40 hours

 

For Units With S/N 465,000 and Higher

1

1

Yearly

8.

Deck Rear Struts

1

2

40 hours

See Section 5.1.16 c) for special lubrication instructions on the front caster pivots and Section 5.1.17 for special lubrication instructions on the front casters wheel hubs.

No. 6 (Mule Drive Belt Idler Arm)

Located Under Engine Frame

No. 7 (Pump Drive Belt Idler Arm)

Located Under Engine Frame

No. 4, 6, & 7 (Idler Pivots)

For Units with S/N 464,999 and Lower: Monthly disassemble belt and spring and grease under a “No Load” condition.

- 34 -

Page 39
Image 39
Exmark Lazer HP manual Lubrication Chart, Service Interval Refer to chart