FIGURE 16
THROTTLE TENSION
5.2.11Electric Clutch Adjustment:
No adjustment necessary.
5.2.12Reverse Indicator Adjustment:
a)Stop engine, wait for all moving parts to stop, and remove key.
b)Unhook seat latch and tilt seat forward.
c)Begin with either the left or right motion control lever. Move lever to the neutral position and pull lever back until the clevis pin (on arm below pivot shaft) contacts the end of the slot (just beginning to put pressure on spring), See Figure 17.
d)Check where lever is relative to notch in console (should be centered allowing lever to pivot outward to the neutral lock position).
e)If adjustment is needed, loosen the nut against the yoke and while applying slight rearward pressure on the motion control lever, turn the head of the adjustment bolt in the appropriate direction until lever is centered (keeping rearward pressure on the lever will keep the pin at the end of the slot and allow the adjustment bolt to move the lever to the appropriate position). Tighten lock nut.
f)Repeat on opposite side of unit.
FIGURE 17
REVERSE INDICATOR ADJUSTMENT
- 42 -
