Extron electronic MPX 866 A manual Example 4 Creating a set of low resolution video and audio ties

Example 4: Creating a set of low resolution video and audio ties

NOTE: This example shows the unusual indications that happen when you make video and audio ties in the low resolution video group.

In the following example, low resolution input 12 is tied to outputs 7 and 8. The steps show the front panel indications that result from your action.

NOTES: • This example does not build on examples 1, 2, and 3. It assumes that there

are no ties in the current configuration.

• When creating video and audio ties in the low resolution video group, audio must be redirected (tied to a different output than the video) because there are only audio outputs 1 through 6. In this case, the audio is tied to an output in the computer video/audio subgroup. See the NOTE on page 24 for redirections.

1.Clear all selections: Press and release the Esc button. The button flashes once.

2.Select video and audio for the tie: If necessary, press and release the Video button and the Audio button until the LEDs light.

I/O

VIDEO AUDIO

Press the Video button to toggle on and off. The LED lights when selected.

Press the Audio button to toggle on and off. The LED lights when selected.

3.Select an input: Press and release the low resolution Input 12 button.

Press and release the Video Input 12 button.

VIDEO INPUTS

10 11 12 13

The LED lights.

MPX 866 A Media Presentation Matrix Switcher • Operation 29