Extron electronic MVX 88 Series manual Furniture mounting the switcher, 1 - Mounting the switcher

Mounting Screws (2 Plcs)	Drill pilot holes
	3/32” (2 mm) dia.,
Each Side
	1/4” (6 mm) deep.

Rack-mount

Bracket (Included)

or

OUTPUTS3

1	4
2

7

									A
							88	VGA
						MVX			R
								L	7
									R
						R		L	8
					L	5
						R
				R	L	6
			L	3
7				R
	1	R	L	4
L	2	R		OUTPUTS
L

5	8
6

RS-232

INPUTS 3

4 1

2

#8 Screw (4 Plcs)	Table/
	Wall-mount
Each Side
	Bracket (Optional)

5

6

8

Figure 2-1 — Mounting the switcher

Furniture mounting the switcher

The MVX Series switchers can be mounted under a table or other horizontal surface with an optional Extron under-desk mounting kit (part #70-222-01).

1.	Secure the two table/wall mounting brackets to the switcher with the eight
	machine screws provided in the kit (figure 2-1).
2.	Hold the switcher with attached brackets against the underside of the desk or
	other furniture. Mark the location of holes for screws on the underside of the
	desk.
3.	Drill 1/4” (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or
	desk at the marked screw locations from the underside/inside (concealed
	side) of the furniture, where the switcher will be located.
4.	Insert the four wood screws into the pilot holes. Fasten each screw into the
	installation surface until just less than 1/4" of the screw head protrudes.
5.	Align the installed screws with the slots in the mounting brackets, and place
	the switcher against the surface, with the screws through the bracket slots.
6.	Slide the switcher slightly forward or back, then tighten all four screws to
	fasten it in place.

PRELIMINARY

MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Installation 2-3