Extron electronic MVX 88 Series manual Preferences menu, 15 - Ties shown as lines, Preliminary

PRELIMINARY

Remote Operation, cont’d

Mute-output settings — Displays the RGB Delay/Mute/Output-Volume Adjust window (figure 4-13), which allows you to mute and unmute the video and audio output for a single output or for all outputs. This window also displays the RGB delay and output volume level settings and allows you to change them.

Update firmware — Allows you to replace the firmware that is coded on the switcher’s control board without taking the switcher out of service, opening the switcher enclosure, and replacing the firmware chip set.

See “Updating the firmware” on page 4-16.

Name presets — Allows you to name each of the 16 memory presets.

Show RS-232 strings — Displays the ASCII commands that are used by the current configuration. You can refer to these for RS-232 programming.

Initialize — Initializes and clears any or all of the following: ties, presets, RGB delay, audio configuration, preset titles, icon names, and icons.

Audio-input Configuration selection — Displays the Configure Audio Options window (figure 4-14), which shows the audio gain level settings for each input and allows you to change them.

Preferences menu

Immediate changes — Causes changes to take effect immediately.

Hold/verify changes — Delays implementation of changes until the Changes – Take button is pressed.

Ties as lines — Displays ties as lines (figure 4-15).

Figure 4-15 — Ties shown as lines

4-20 MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Remote Operation