Extron electronic MVX 88 Series manual Matrix Switchers Control Program, Installing the software

Matrix Switchers Control Program

The Windows®-based Extron Matrix Switchers Control Program, which communicates with the switcher via the rear panel Remote RS-232 port provides an easy way to set up ties and sets of ties. The program is compatible with Windows 2000 and Windows XP.

Installing the software

The program is contained on the Extron Software Products CD-ROM, disk B.

Install the software as follows:

NFor full functionality, install both of the following programs:

•The Matrix Switchers Control Program

•The Firmware Loader

1. Insert the CD-ROM into the drive. The installation program should start

automatically. If it does not self-start, run Launch.exe from the CD. The Extron software CD window appears (figure 4-6).

PRELIMINARY

Figure 4-6 — Software CD window

2.	Click the Software tab (figure 4-6).
3.	Scroll to the desired program and click Install (figure 4-7).

Figure 4-7 — Software installation

MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Remote Operation 4-13