Extron electronic MVX 88 Series If an input with no tie is selected, only that input’s LED lights

•If, when you are configuring video and audio ties, the Audio LED blinks and the Video LED is on after you have selected an input or output, the LEDs indicate audio breakaway, meaning that the audio ties are not the same as the video ties for that input.

•If an input with no tie is selected, only that input’s LED lights.

•As each output is selected, the associated output LED blinks to indicate a tentative tie until you press the Enter button or the 5-second timeout expires. LEDs for output(s) that were already tied to the input light steadily. Outputs that are already tied can be left on, along with new blinking selections, or toggled off by pressing the associated output button.

•If you inadvertently press the wrong input or output button, wait approximately 5 seconds. The input and output button selections time out and are abandoned.

Example 1: Create a set of video and audio ties

In the following example, input 5 is tied to outputs 3, 4, and 8. The example shows the front panel indications that result from your actions.

NThis example assumes that there are no ties in the current configuration.

1. Select video and audio for the tie (figure 3-3).

Press the button to cycle through the selections.

I/O

The video LED lights when video is selected. VID

The audio LED lights when audio is selected. AUD

Figure 3-3 — Select video and audio

2. Press and release the Input 5 button (figure 3-4).

Press and release the Input 5 button.

INPUTS

1 2 3 4 5 6 7 8

The Input 5 LED lights to indicate that input 5 is selected.

Figure 3-4 — Select an input

MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Operation 3-7

PRELIMINARY