Extron electronic RGB 201 Rxi manual Installation and Operation, cont’d Mounting the Interface

Installation and Operation, cont’d

Mounting the Interface

The interface can be mounted on tabletops, under desks, through desks, or on racks, as described in this section.

Tabletop placement

For tabletop or desktop placement only, install the self-adhesive rubber feet/pads (provided) onto the four corners of the bottom of the interface enclosure.

Under-desk mounting

1. Secure the optional under-desk mounting brackets (part #70-077-01) to the interface with the six machine screws provided in the mounting kit (figure 2-3).

LEVEL
	PEAK
BOOST		CENTERING
	CONTROL

R
GB
20	1Rxi
		WITH
		ADSPTM

Figure 2-3 — Under-desk mounting

2. Hold the interface with attached brackets against the underside of the desk or other furniture. Mark the location of holes for screws on the desk.

3. Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or desk at the marked screw locations from the underside/inside (concealed side) of the furniture, where the interface will be located.

2-6 RGB 201 Rxi Universal Interface • Installation and Operation