4. Insert the four wood screws into the pilot holes. Fasten each screw into the installation surface until just less than 1/4" of the screw protrudes.
5. Align the installed screws with the slots in the mounting brackets, and place the interface against the surface, with the screws through the bracket slots.
6. Slide the interface slightly forward or back, then tighten all four screws to fasten it in place.
Through-desk mounting
1. If rubber feet were installed on the interface, remove them.
Figure 2-4 — Through-desk mounting
RGB 201 Rxi Universal Interface • Installation and Operation |
